<b id="hdljt"><span id="hdljt"></span></b><var id="hdljt"></var>

    <ins id="hdljt"><span id="hdljt"></span></ins>

    <output id="hdljt"><noframes id="hdljt">

      <del id="hdljt"><span id="hdljt"></span></del>
        <b id="hdljt"><track id="hdljt"></track></b>
        <del id="hdljt"><track id="hdljt"></track></del>

          <font id="hdljt"><noframes id="hdljt"><font id="hdljt"></font>

          <var id="hdljt"></var>
            <b id="hdljt"><track id="hdljt"></track></b><font id="hdljt"><track id="hdljt"><dfn id="hdljt"></dfn></track></font>
            <var id="hdljt"></var>

              <menuitem id="hdljt"><em id="hdljt"><thead id="hdljt"></thead></em></menuitem><var id="hdljt"><pre id="hdljt"><thead id="hdljt"></thead></pre></var>

                  山東山汽工程機械(集團)有限公司
                  熱線電話:400-879-1999 山汽官方微信
                  鄭重聲明 購機 售后
                  在線詢價
                  熱線電話:400-879-1999
                  您現在所在的位置: 首頁> 新聞資訊 > 行業新聞 >

                  作為自動上料攪拌車管理者需要知道的事項

                  所屬分類:行業新聞 發布時間:2022-04-27 來源:http://www.frabur.com 瀏覽量:18

                  作為自動上料攪拌車管理者需要知道的事項
                  Matters to be known as the manager of automatic feeding mixer truck
                  自動上料攪拌車操作者需要經過相關的培訓,熟悉其操作規則。小編認為,作為自動上料攪拌車操作者您需要做好以下四個方面工作。
                  The operator of automatic feeding mixer truck needs to be trained and familiar with its operation rules. Xiaobian believes that as an operator of automatic feeding mixer truck, you need to do the following four aspects.
                  一、預防混凝土粘罐。在施工現場卸料完畢后,應立即用攪拌車隨帶的軟管沖洗進料斗、出料斗、卸料熘槽等處,清理粘附在車身各處的污泥及混凝土。在返回攪拌站的途中,應向攪拌筒內注150---200L水以清洗筒壁及葉片粘結的混凝土殘渣。每天工作結束后,司機應負責向攪拌筒內注入清水并高速(14—18轉/分)旋轉5—10分鐘,然后將水排去,以保證筒內清潔。用高壓水清洗攪拌筒各個部分時,應注意避開儀表及操縱桿等部位。壓力水噴嘴與車身油漆表面間的距離不得小于40厘米。
                  1、 Prevent concrete from sticking to the tank. After unloading at the construction site, immediately flush the inlet hopper, outlet hopper and unloading chute with the hose attached to the mixer truck, and clean the sludge and concrete adhered to the vehicle body. On the way back to the mixing plant, 150-200l water shall be injected into the mixing drum to clean the concrete residue bonded to the drum wall and blades. At the end of each day's work, the driver shall be responsible for injecting clean water into the mixing drum and rotating at high speed (14-18 RPM) for 5-10 minutes, and then drain the water to ensure the cleanness of the drum. When cleaning all parts of the mixing drum with high-pressure water, pay attention to avoid instruments, control rods and other parts. The distance between the pressure water nozzle and the paint surface of the vehicle body shall not be less than 40cm.
                  自動上料攪拌車廠家
                  Automatic feeding mixer manufacturer
                  二、清潔工作。清理攪拌筒內外積污及殘存的混凝土渣塊時,以及在機修人員進入筒內進行檢修和焊補作業時,需先關閉汽車發動機,使攪拌筒完全停止轉動。在機修人員進入筒內工作期間,須保證拌筒內通風良好,空氣新鮮,無可然氣體及有害灰塵,氧氣供應充足。在筒內使用電動工具操作時,操作人員須有良好的絕緣保護。
                  2、 Cleaning work. When cleaning the dirt and residual concrete slag inside and outside the mixing drum, and when the mechanical maintenance personnel enter the drum for maintenance and welding repair, it is necessary to turn off the automobile engine first to stop the mixing drum completely. During the working period when the mechanical maintenance personnel enter the drum, they must ensure that the mixing drum is well ventilated, the air is fresh, there is no combustible gas and harmful dust, and the oxygen supply is sufficient. When using electric tools in the cylinder, the operator must have good insulation protection.
                  三、防護工作。在自動上料攪拌車工作時,不得將手伸入旋轉的攪拌筒內,嚴禁將手伸入主卸料熘槽和加長卸料熘槽的連接部位,以免發生事故。
                  3、 Protection work. When the automatic loading mixer works, do not put your hand into the rotating mixing drum, and do not put your hand into the connecting part of the main unloading frying groove and the extended unloading frying groove, so as to avoid accidents.
                  四、液壓系統壓力應符合使用說明書中的規定,不得隨意調整。液壓油的油質和油量應符合原定要求。
                  4、 The pressure of the hydraulic system shall comply with the provisions in the operation manual and shall not be adjusted at will. The oil quality and quantity of hydraulic oil shall meet the original requirements.
                  以上就是為大家介紹的有關自動上料攪拌車的詳細介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.frabur.com/
                  The above is a detailed introduction to the automatic feeding mixer truck. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.frabur.com/
                  熱門產品 / HOT PRODUCT

                   

                  首頁 產品 電話 置頂
                  国内一级一级毛片a免费观看_国内一级婬片A片免费网_国内一级婬片A片免费张_国内又黄又刺激又爽视频_国内揄拍国内,精品人妻